Techne TC-3000X Manuel d'utilisateur télécharger pdf (Page 28)

PROGRAMMING THE TC-3000 & TC-3000X

The table below illustrates the symbols which appear on the LCD display and the relevant keypad button

to which they refer.

In the prompt line is equivalent to the "End" key.

On a program line means the program is locked;

it can be copied and then edited but not edited directly.

Up arrow

Down arrow

Enter

Pause

The following terms are used when programming the thermal cyclers:

Stage A 'Stage' is the name given to the main repeated part of a program containing the 'Steps' to be

repeated. A program can contain a maximum of 25 stages although typically only one or two

are used.

Cycle A 'Cycle' is the number of repetitions of a 'Stage'

Step A 'Step' is a user defined program line containing a temperature, a hold time and ramp rate.

Typically three steps are created within one 'Stage'.

To enter the programming section of the

software, highlight 'Programs' using the

"Up Arrow" or "Down Arrow" keys

Press "Enter"

This screen lists all the programs saved on the

unit. Use the "Up Arrow" and "Down Arrow"

keys to scroll through the list.

The number next to the program name is the

unique "Speed dial" number allocated to the

program for rapid retrieval (see below).

Programs [0]

Information

Configuration

[ , to select ]

* * New Program * * [ ]

2 STEP TEMPLATE 501

3 STEP TEMPLATE 502

[ , to select ]

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 54 55

Pas de commentaire

Techne TC-3000X Manuel d'utilisateur Page 28