Techne TC-3000X Manuel d'utilisateur télécharger pdf (Page 23)

HEATED LID: TC-3000

To release the heated lid, lift the lid catch and the

lid will open. To close the lid, push down gently

until the catch clicks in place. Do not close the

lid without tubes being fitted in the block.

HEATED LID: TC-3000X

The heated lid has a rotating knob to adjust the lid

pressure on the samples, allowing for a variety of

consumables to be used. To adjust the pressure:

• Adjust the orange rotating knob anticlockwise

to give the least pressure.

• Place the samples in the block and place the lid

in the down position.

• Gently rotate the knob clockwise until you can

feel pressure beginning to be applied.

• Rotate the knob a further quarter of a turn and

this will give the correct pressure.

USER OPERATION AND CONSUMABLES

Do not over-tighten the knob as this will cause deformation of the silicone rubber mat (where used) and

reduce the effectiveness of the lid. Once the pressure has been set it does not need to be adjusted unless

a different block or consumable is used.

The silicone rubber mat supplied with the unit (Part number 6106196) is for use with 48 well microplates

when sealing using a plastic adhesive film. The mat should be placed on top of the sealing film to ensure

good thermal contact with the heated lid.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 54 55

Pas de commentaire

Techne TC-3000X Manuel d'utilisateur Page 23